1. Read the safety information that begins on page v and “Installation guidelines”
on page 16.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables. Remove the cover (see “Removing the cover” on page 18).
3. Press the release tab (the rear of the drive-retention clip) toward the drive to
release the clip; then, while pressing the tab, pull the drive out of the bay.
Note: You might have to push the right-rear corner of the drive toward the front
of the server to move the drive initially.
4. Remove the retention clip from the drive and save it for future use.
To
install a CD or DVD drive, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 16.
2. Make sure that the server and peripheral devices are turned off and that the
power cords and all external cables are disconnected. Remove the cover (see
“Removing the cover” on page 18).
3. Follow the instructions that come with the drive to set any jumpers or switches.
Chapter 2. Installing optional devices 27
To Next Page
Loading...
