Select this choice to view the system resources that are used by installed PCI
devices.
– IPMI
Select this choice to change intelligent platform management interface (IPMI)
settings for the mini-BMC controller.
- IPMI Specification Version
This is a nonselectable menu item that displays the IPMI version.
- BMC Hardware/Firmware Version
This is a nonselectable menu item that displays the BMC firmware version.
- Clear System Event Log
Enable or disable clearing the system-event log at the next system startup,
which occurs when you save the settings and exit the Configuration/Setup
Utility program. Disable is the default setting.
- Existing Event Log number
This is a nonselectable menu item that displays the number of entries in
the system-event log.
- BIOS POST Watchdog
Enable or disable the mini-BMC POST watchdog. Disable is the default
setting.
- POST Watchdog Timeout
Set the mini-BMC POST watchdog timeout value. 5 minutes is the default
setting.
- System Event Log
Select this choice to view the mini-BMC system-event log, which contains
all system-error messages that have been generated. Use the arrow keys
to move between pages in the log. Run the diagnostic programs to get
more information about error codes that occur. See the Problem
Determination and Service Guide on the IBM System x Documentation CD
for instructions. Select Clear System Event Log to clear the mini-BMC
system-event log.
Important: If the system-error LED on the front of the server is lit but there
are no other error indications, clear the system-event log. This log does not
clear itself, and if it begins to fill up, the system-error LED will be lit. Also,
after you complete a repair or correct an error, clear the system-event log
to turn off the system-error LED on the front of the server.
- LAN Settings
Select this choice to view the mini-BMC MAC address, IP address, subnet
mask, and gateway address.
–
RSA II Settings
This
choice is displayed only when a Remote Supervisor Adapter II SlimLine
is installed in the server.
Select this choice to view the IP address and DHCP settings for the Remote
Supervisor Adaptor II SlimLine, and to view or change the DHCP control,
static IP address, and operating system USB selections for the Remote
Supervisor Adaptor II SlimLine.
v Error Logs
Select this choice to view or clear error logs.
– POST Error Log
Select this choice to view the three most recent error codes and messages
that the system generated during POST.
– System Event/Error Log
40 IBM System x3250 Types 4364 and 4365: User’s Guide
To Next Page
Need help?
General
