p. If you have another drive to install or remove, do so now.
q. Replace the left-side cover and bezel; then, lock the left-side cover and
bezel.
r. Reconnect the external cables and power cords.
2. To install the UltraSlim DVD drive on models with eight 3.5-inch, complete
the following steps:
v Locate the documentation that comes with the drive and follow those
instructions in addition to the instructions in this chapter.
v Make sure that you have all the cables and other equipment that are
specified in the documentation that comes with the drive.
v The server supports one ultra-slim SATA optical drive.
a. If you are replacing a drive, make sure that:
v You have all the cables and other equipment that are specified in the
documentation that comes with the new drive.
v You have checked the instructions that come with the new drive to
determine whether you must set any switches or jumpers in the drive.
v You have removed the blue optical drive rails from the side of the old
drive and have them available for installation on the new drive.
Note: If you are installing a drive that contains a laser, observe the
following safety precaution.
Statement 3:
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic
devices, or transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product
could result in exposure to hazardous laser radiation. There are no
serviceable parts inside the device.
v Use of controls or adjustments or performance of procedures other
than those specified herein might result in hazardous radiation
exposure.
Chapter 2. Installing optional devices 65
To Next Page
Loading...
Need help?
General