EasyManuals Logo

IBM System x3400 M3 Types 7378 User Manual

IBM System x3400 M3 Types 7378
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
Installing a hot-swap hard disk drive
The following notes describe the types of hard disk drives that the server supports
and other information that you must consider when you install a hard disk drive:
v The server supports up to sixteen 2.5-inch, SAS/SATA hot-swap hard disk drives
or up to eight 3.5-inch, SAS/SATA hot-swap hard disk drives in the standard
hot-swap bays depending on your model.
Note: SAS expander card does not support 3 GB RAID adapters.
v The hot-swap drives are arranged horizontally in the standard hard disk drive
cage.
v On models with 2.5-inch hard disk drives, the drive numbers are 0 through 7
(right to left). 8 through 15 (right to left). 16 through 23 (right to left). When you
install hard disk drives, start with drive 0.
v On models with four 3.5-inch hard disk drives, the drive numbers are 0 through 3
(left to right). On models with eight 3.5-inch hard disk drives, hard disk drive cage
for 4 through 7 (left to right) is added.
v For a list of supported optional devices for the server, see http://www.ibm.com/
servers/eserver/serverproven/compat/us/ .
v Inspect the drive tray for signs of damage.
v Make sure that the drive is correctly installed in the tray.
v See the documentation for the ServeRAID adapter for instructions for installing a
hard disk drive.
Note: For proper cooling, do not install any card in the slot next in sequence to
a ServeRAID adapter with battery backup module (for example, if a ServeRAID
adapter with battery backup module is installed in slot 2, do not install any card
in slot 3).
v All hot-swap drives in the server must have the same throughput speed rating;
using drives with different speed ratings might cause all drives to operate at the
speed of the slowest drive.
v To minimize the possibility of damage to the hard disk drives when you are
installing them in a rack configuration, install the server in the rack before you
install the hard disk drives.
v You do not have to turn off the server to install hot-swap drives in the hot-swap
drive bays. However, you must turn off the server when you perform any steps
that involve installing or removing cables.
v The drive ID of each hot-swap hard disk drive is printed on the hard disk drive
cage.
Chapter 2. Installing optional devices 75

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM System x3400 M3 Types 7378 and is the answer not in the manual?

IBM System x3400 M3 Types 7378 Specifications

General IconGeneral
ProcessorIntel Xeon 5600 series
Memory Slots12 DIMM slots
Hard Drive BaysUp to 8 bays
Network InterfaceDual Gigabit Ethernet
ManagementIntegrated Management Module (IMM)
Form FactorTower
Processor Cores4 or 6 cores
ChipsetIntel 5520
StorageSAS/SATA
RAID SupportRAID 0, 1, 10
Power SupplyRedundant Power Supply Options Available
Expansion Slots4 PCI-Express slots
USB Ports6 USB 2.0
Operating System SupportMicrosoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware

Related product manuals