EasyManuals Logo
Home>IBM>Laptop>ThinkPad 380

IBM ThinkPad 380 Hardware Maintenance Manual

IBM ThinkPad 380
717 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #644 background imageLoading...
Page #644 background image
 If the external monitor is attached to the display
adapter card:
1. Display adapter card.
2. Main card.
3. Riser card.
4. External monitor.
Printer
Test the printer by connecting it to the computer before
testing it on the SelectaDock Docking System.
1. Make sure the printer is correctly connected and the
power is turned on.
2. Run the printer self-test.
If the printer self-test does not run correctly, the problem is
in the printer. Refer to the printer service manual.
If the printer self-test runs correctly, connect the
Tri-Connector wrap plug (P/N 72X8546) on the parallel
connector of the computer, and run the advanced
diagnostic tests to determine the failing FRU.
If the advanced diagnostic tests (with the wrap plug
connected) did not detect a failure, replace the printer
cable.
If the diagnostic detected the error, replace the system
board of the computer.
 If the printer is attached to the parallel connector of
the SelectaDock Docking System, replace the port
replicator of the SelectaDock Docking System.
 If the printer is attached to the parallel connector on
the adapter, replace the FRUs in the following order
one at a time until the problem is corrected:
Note: If the replaced parts did not resolve the
problem, put the original parts back in the
SelectaDock Docking System. Do not replace
nondefective parts.
1. Adapter.
2. Main card.
USB Device
Test the USB (universal serial bus) device by connecting it
to the computer before testing it on the SelectaDock
Docking System.
1. Make sure the USB device is correctly connected and
the power is turned on.
2. Run the device self-test.
If the device self-test does not run correctly, the problem is
in the device. Refer to the device service manual.
If the device self-test runs correctly, connect the USB
parallel test cable (P/N 05K2580) on the USB connector
SelectaDock III (3547-003) 631

Table of Contents

Other manuals for IBM ThinkPad 380

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM ThinkPad 380 and is the answer not in the manual?

IBM ThinkPad 380 Specifications

General IconGeneral
BrandIBM
ModelThinkPad 380
CategoryLaptop
LanguageEnglish

Related product manuals