Getting Started
7
8
Adjust the LCD angle so that it is convenient for viewing; then slide the speaker volume control to
the middle position and position the brightness control (
) and the contrast control ( ) as
shown. (Only the DSTN model has a contrast control.)
9
Connect the AC Adapter as shown.
DANGER
Do not attempt to open the AC Adapter case. The AC Adapter is permanently
sealed and cannot be repaired.
Attention:
Always use an AC Adapter certified by IBM in the country where you will be using the computer.
Operating the computer with an incorrect AC Adapter can cause damage to the battery pack and
to the computer.
10
Push and release the power switch to turn on the computer.
The power switch automatically snaps back to its original position.
A You can raise the keyboard to an angle for easy typing by sliding the keyboard raiser A (used
in step 2 on page 7) away from you.
or:
B When you want to type on a flat keyboard, lock the flat keyboard position by sliding the
keyboard latches B away from you.
Attention:
Remember to push the keyboard latches toward the front of the computer whenever you close
the LCD.
Chapter 1. Getting Started 11
To Next Page
Loading...
