v  Press  the  Fn+F12  keys. 
v  If  you  are  using  the  APM  operating  system  and  have  set 
the  mode  to  Power  switch  mode  [Hibernation],  turn 
off  the  power  switch. 
v  If  you  are  using  the  ACPI  operating  system  and  have 
defined  one  of  the  following  actions  as  the  event  that 
causes  the  system  to  go  into  hibernation  mode,  perform 
that  action. 
–  Closing  the  lid. 
–  Pressing  the  power  button. 
–  Pressing  Fn+F4  keys.
Also,  the  computer  goes  into  hibernation  mode 
automatically  in  either  of  the  following  conditions:
v
  If  a  “hibernation  time”  has  been  set  on  the  timer,  and  the 
user  does  not  do  any  operation  with  the  keyboard,  the 
TrackPoint,  the  hard  disk  drive,  the  parallel  connector,  or 
the  diskette  drive  within  that  time. 
v  If  the  timer  conditions  are  satisfied  in  suspend  mode. 
v  If  you  are  using  the  APM  operating  system  and  have  set 
the  mode  to  Hibernate  when  battery  becomes  low, 
and  the  battery  charge  becomes  critically  low. 
When  the  power  is  turned  on,  the  computer  returns  from 
hibernation  mode  and  resumes  operation.  The  hibernation 
file  in  the  boot  record  on  the  hard  disk  drive  is  read,  and 
system  status  is  restored  from  the  hard  disk  drive. 
Checkout  guide 
Use  the  following  procedures  as  a  guide  in  identifying  and 
correcting  problems  with  the  ThinkPad  computer. 
Note:  The  diagnostic  tests  are  intended  to  test  only  IBM 
products.  The  use  of  non-IBM  products,  prototype 
cards,  or  modified  options  can  lead  to  false 
indications  of  errors  and  invalid  system  responses. 
1.  Identify  the  failing  symptoms  in  as  much  detail  as 
possible. 
2.  Verify  the  symptoms.  Try  to  re-create  the  failure  by 
running  the  diagnostic  test  or  by  repeating  the 
operation.
Testing  the  computer 
The  ThinkPad  computer  has  a  test  program  called 
PC-Doctor
®
 
DOS  (hereafter  called  PC-Doctor).  You  can 
detect  errors  by  running  the  diagnostics  test  included  in 
PC-Doctor.  This  section  is  an  overview  of  the  procedure. 
For  details  that  depend  on  model-unique  functions,  refer  to 
“Product  overview”  on  page  51. 
Related  service  information  
42  MT  2369/2370/2371/2372/2382/2386