Ethernet and systems-management connectors:
IMM2 dedicated mode (default) :
In this mode, which is the default setting for the server, the Ethernet 2 connector
connects to a network for full systems-management information control. A dedicated
management network provides additional security by physically separating the
management network traffic from the production network. Meanwhile, the Ethernet
1, Ethernet 3 and Ethernet 4 connectors are used to connect to the production
network. See “Using the Setup utility” on page 99 for more information.
IMM2 shared mode :
In this mode, the Ethernet 1 connector is used to connect to both the management
network and production network. Meanwhile, the Ethernet 2, Ethernet 3 and
Ethernet 4 connectors are used to connect to the production network. See “Using
the Setup utility” on page 99 for more information.
PCI slot connectors:
Chapter 1. The System x3630 M4 Type 7158 server 19
To Next Page
Loading...
