v For 2U PCI riser card assembly:
– PCI slot 1: Insert a full-height, full-length PCI Express adapter into this slot.
– PCI slot 2: Insert a full-height, half-length PCI Express adapter into this slot.
– PCI slot 3: Insert a low-profile PCI Express adapter into this slot.
– PCI slot 4: Insert a low-profile PCI Express adapter into this slot.
– PCI slot 5: Insert a low-profile PCI Express adapter into this slot.
For 1U PCI riser card assembly:
– PCI slot 1: Insert a full-height, half-length PCI Express adapter into this slot.
– PCI slot 2: Insert a low-profile PCI Express adapter into this slot.
– PCI slot 3: Insert a low-profile PCI Express adapter into this slot.
Power-cord connector: Connect the power cord to this connector.
USB connectors: Connect a USB device, such as USB mouse or keyboard to
either of these connectors.
NMI button: Press this button to force a nonmaskable interrupt to the
microprocessor. It allows you to blue screen the server and take a memory dump
(use this button only when directed by the IBM service support). You might have to
use a pen or the end of a straightened paper clip to press the button.
Serial connector: Connect a 9-pin serial device to this connector. The serial port is
shared with the integrated management module II (IMM2). The IMM2 can take
control of the shared serial port to perform text console redirection and to redirect
serial traffic.
Video connector: Connect a monitor to this connector. The video connectors on
the front and rear of the server can be used simultaneously.
Note: The maximum video resolution is 1600 x 1200 at 75 Hz.
20 System x3630 M4 Type 7158: Installation and User’s Guide
To Next Page
Loading...
