Biotech-Lab User Manual \\ 22www.ibpmedical.com
Display To Use For Temperature Coefficient Temperature Coefficient
at 25°C at 37°C
RO-PPW Reverse Osmosis PPW 2,200 %/K RO-PPW
Phoenix Pure Water GmbH Reference temperature 25°C
Siemens Technopark
Werner-von-Siemens-Str. 2-6
D-76646 Bruchsal - Germany
7.2 TEMPERATURE SENSOR DETAILS
The following menu shows the settings for temperature sensors.
Head area shows the serial number and the date of last calibration.
Select here the unit you like to see.
7.3 PRESSURE SENSOR DETAILS
The following menu shows the settings for pressure sensors.
Head area shows the serial number and the date of last calibration.
Select here the unit you like to see.
Allows selecting a higher resolution for the reading.
Allows taring the sensor.
Allow selecting the damping factor.
Starts a pressure change measurement.
7.3.1 OFFSET BALANCING (TARE)
Caused by drift of the pressure probe, the pressure display may sway slightly around zero. The tare function sets the value to
zero if drift occurs. While performing this function there must not be any pressure on the pressure transducers inlet. This is
assured when the pressure tube is not connected. Then the environmental pressure represents zero.
To Next Page
Loading...