Biotech-Lab User Manual \\ 4www.ibpmedical.com
Safety Instructions
Read this First
FOR YOUR SAFETY READ AND CONSIDER THE SAFETY INSTRUCTIONS BELOW CAREFULLY
• Read carefully the entire user manual of the Biotech-Lab system before using the Biotech-Lab system.
• Read carefully the entire manual of the devices under test before connecting the Biotech-Lab system to the devices under
test.
• The battery included with the HDC75 does not arrive fully charged. The battery must be charged for a minimum of 2 hours
prior to use.
• Keep the devices away from unauthorized persons.
• Make sure that all Biotech-Lab Modules have valid calibration certificates.
• Only use the Biotech-Lab system in a dry environment and do not touch it with wet hands.
• Prevent every mechanical overstraining of electrical wires.
• If the acquired values seem to be not believable, make sure that the no device is defective.
• Prevent electrostatic discharge on the connectors. This can lead to substantial damage of the Biotech-Lab devices and
devices under test. Make sure to be completely discharged before touching the connectors or cables connected to the
instrument.
• Potentials above 42 V against earth ground are dangerous. This potentials can lead to electrical shock and therefore to
health hazards. Make sure that none of the connectors has higher voltage than mentioned before.
• Never open a device of the Biotech-Lab system. There are no serviceable parts inside.
To Next Page
Loading...