FAULTS
When there is error for the fridge, the code will show on the display. The possible error for each code
would be as follows.
ERROR TYPE
ERROR CODE
E1
The low battery protection mode take effect (the input voltage is lower than set value)
E2 Fan error
E3
Compressor motor start error (Motor block or refrigeration system pressure
difference is too large)
E4
E5
E6
The motor speed of the compressor is too low (the refrigeration system is overloaded,
the motor cannot maintain the minimum speed of 1850r/min)
Temperature too high or too low to protect the compressor control module (when the
environment temperature is too high or too low, or system load is too large, causing
module/ECU internal temperature 100°C ＞or ＜-10°C)
NTC fault (NTC open circuit or short circuit)
6
To Next Page
Loading...
Need help?
General
