Tag name ID 34+35
Error extruder plate changer 1
and 2.
1. The small hydraulic cylinder that lifts the
extruder plate is not in the correct
position.
In "Single mode" try to move the cylinder
to the wanted position.
Check the if the Balluff tranducer is
working.
Yes, the Balluff transducer is not
working correctly.
Try to recalibrate the transducer
it might be nesecarry to reset
before the calibration can be
carried out. See procedure 9.
The wire connection and plug
could have a failure => repair or
replace components.
The transducer it self can have an
internal failure => replace the
component.
Reset and restart
the Pelletizer.
No, there is no problems.
? Contact IceTech
technical support.
To Next Page