16
Symptom Remedy
The system isn’t turning on Check the wiring (see Installation, Page 4)
Check the batteries (SC2000 only)
LCD is blank, or displaying “LO BAT” SC2000: Replace batteries, or make sure the existing ones are properly
installed (see Installing and Changing Batteries, Page 6)
SC2001: Verify 24 VAC is at thermostat.
Thermostat is not properly controlling the fan Check that the Gas/Electric jumper setting matches your system (gas
or electric)
Thermostat is continuously turning on and off Increase the temperature differential (see Setting a New Temperature
Differential, Page 15)
Temperature displayed is not accurate Verify no heat producing objects are located near the thermostat.
Verify thermostat has adequate air flow to it.
Troubleshooting
To Next Page
Loading...
