8
2
PANEL DESCRIPTION
@4 KEYPAD [0]–[9], [•], [CE] (p. 17)
➥[0] to [9] are used to input a receive frequency or mem-
ory channel directly.
➥[•] (Decimal) button is used to set the MHz digit when in-
putting a frequency.
➥[CE] (Clear) button is used to clear mistakes while in-
putting a receive frequency or memory channel.
@5 IF FILTER BUTTONS [NAR]/[WID] (p. 20)
Push to change the IF filter in use. The [WID] button se-
lects a wider filter, the [NAR] button selects a narrower fil-
ter.
•Usable IF filters vary according to receive mode.
@6 SCAN STOP BUTTON [STOP] (p. 26)
Push to cancel scan operation.
@7 PROGRAMMED SCAN BUTTON [PROG] (p. 27)
Push to start/stop programmed scan.
•“PROG”flashes while scanning.
@8 SPAN +/– BUTTONS [SPAN+]/[SPAN–] (p. 34)
Push to select one of four levels for the band scope fre-
quency span.
@9 AUTO MEMORY WRITE SCAN BUTTON [AUTO] (p. 29)
Push to start/stop auto memory write scan.
•“AUTO”flashes while scanning.
To Next Page
Loading...
