Icom IC-2820H - Page 105

84
10
DTMF MEMORY ENCODER
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
D Transmitting a DTMF memory directly
z Push [FUNC] then [ LOW 6(DTMF)] to turn the
DTMF memory encoder ON.
•“
☎
” appears.
x Push [DTMF-S] to turn the DTMF memory di-
rect selection ON.
• The function indicator (microphone) lights green.
c Push the desired DTMF channel.
• “0” to “9,” “A” to “D,” “✱” and “#” are available for
DTMF memory channels.
• The selected DTMF tone sequence is automatically
transmitted without pushing PTT.
NOTE: When no DTMF tone sequence pro-
grammed channel number is pushed, it transmits
the relative DTMF tone sequence as the manual
transmission described as at right.
v Push [DTMF-S] again to deactivate the DTMF
memory direct selection.
b Push [FUNC] then [
SET B(D-OFF)] to cancel
the DTMF memory encoder.
D Manual transmission
z Deactivate the DTMF memory encoder by
pushing [FUNC] then [
SET B(D-OFF)].
x Push [DTMF-S] to turn the DTMF direct selec-
tion ON.
• The function indicator (microphone) lights green.
c Push one of “0” to “9” and “A” to “F” keys mo-
mentarily, then push the desired DTMF keys,
0–9 and A to F.
• A: [ CLR
A(MW)] B: [ SET B(D-OFF)],
C: [
ENT C(T-OFF)] D: [ SQL Y D(MUTE)],
E: [✱(TONE-1)] F: [ SQL Z #(16KEY-L)]
• Automatically transmits without pushing PTT.
• The first code entering will not transmitted. DTMF
code transmission starts from the 2nd code.
v Push [DTMF-S] again to deactivate the DTMF
direct selection.
DTMF-S
DTMF-S