Icom IC-2820H

103
14
MENU SCREEN OPERATION
■ DV SET MODE items
The following items are selectable by optional UT-123 is in-
stalled into the IC-2820H.
DD
Auto reply
This function replies to an individual station call even you are
away from the transceiver.
After a manual transmission (pushing [PTT]), the Auto Reply
setting returns to OFF automatically.
• OFF : No reply is performed even a call is received.
(default)
• ON : Sets caller’s call sign and reply to the call with
the set own call sign automatically.
• VOICE : Reply to the call with the recorded voice
memory.
DD
Digital code
Sets the desired digital code for digital code squelch opera-
tion. A total of 100 codes (00–99) are available.
(default: 00)
DD
DV data TX
During low-speed data operation, auto data transmission
function is available. This function transmits when data has
been input from PC via the [DATA] jack.
(default: PTT)
DD
Digital monitor
Sets the desired monitoring mode during DV mode operation
from “AUTO,” “DIGITAL” and “ANALOG.”
• AUTO : The transceiver sets monitoring mode to FM
and DV according to the received signal.
(default)
• DIGITAL : Monitors in DV mode.
• ANALOG : Monitors in FM mode.
DD
Digital repeater setting
When accessing a digital repeater with a call sign different
than is programmed, the repeater call sign can be stored into
“RPT1” and/or “RPT2” automatically by reading the repeater’s
transmission. The stored repeater’s call sign can be re-called
when selecting the repeater call sign.
(default: OFF)
DD
RX call sign auto write
When an individual station call is received, the calling station
call sign can be automatically set in “YOUR.”
(default: OFF)