88
11
TONE SQUELCH AND POCKET BEEP
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
D Setting DTCS code
q Push [F•]to display the function guide.
w Push [MENU](V/MHz•SCAN)
(Right band’s) to enter MENU
screen.
e Rotate [DIAL] to select “DUP/TONE…” then push
[MAIN•BAND].
r Rotate [DIAL] to select “DTCS CODE” then push
[MAIN•BAND].
t Rotate [DIAL] to select the desired DTCS code then push
[MAIN•BAND].
• Each operating band and each memory channel have indepen-
dent settings.
• See the table at right for available DTCS code.
y Push [BACK](V/MHz•SCAN) (Right band’s)
to exit from
DUP/TONE set mode.
DTCS mode can be selected in “DTCS POLARITY” menu.
(p. 89)
z Push [
SET
B(D-OFF)] to enter set mode.
x Push [Y]/[Z] several times to select
“DUP/TONE…” then push [
SET
B(D-OFF)].
c Push [Y]/[Z] several times to select “DTCS
CODE” then push [
SET
B(D-OFF)].
v Push [Y]/[Z] to select the desired DTCS code
then push [
SET
B(D-OFF)].
b Push [
CLR
A(MW)] to exit DUP/TONE set mode.
•Available tone frequency
•Available DTCS code
To Next Page
Loading...
