Icom IC-2820H - Page 66

45
5
DV MODE OPERATION (Optional UT-123 is required)
DD
Repeater operation into another zone
qSet the desired repeater’s frequency, offset and shift direc-
tion in the main band.
(pgs. 30, 31)
• Select DV mode in advance. (p. 21)
wSet your own call sign. (p. 39)
• See p. 37 for your own call sign programming.
eSet the desired station call sign. (p. 40)
•When making a CQ call
Set the desired repeater’s
(in a different zone) call sign into
“YOUR.” The symbol “/” which stands for “CQCQCQ” is
added at the 1st digit automatically.
• See p. 38 for station call sign programming.
rSet the repeater’s call sign as follows;
zPush [F•]twice to display the function guide 2.
xPush [CS](V/MHz•SCAN)
(Left band’s) to display the
“CALL SIGN” screen.
cRotate [DIAL] to select “RPT1,” then push
[MAIN•BAND].
• RPT1 CALL SIGN screen is displayed.
vRotate [DIAL] to select the nearest repeater’s call sign
then push [BACK](V/MHz)
(Right band’s).
• If the nearest repeater is a gateway repeater, program the re-
peater’s call sign with “G” in the 8th digit.
bRotate [DIAL] to select “RPT2” then push
[MAIN•BAND].
• RPT2 CALL SIGN screen is displayed.
nRotate [DIAL] to select the gateway repeater’s (in the
same zone) call sign.
• The call sign should have “G” in the 8th digit.
• When gateway repeater call sign is set in “RPT1,” select “NOT
USE✱” for “RPT2” setting.
mPush [BACK](V/MHz•SCAN) (Right band’s) to exit “CALL
SIGN” screen.
tPush [PTT] to transmit; release to receive.