Icom IC-706MKIIG - Page 55

52
15 DUP HF
((dduupplleexx ooffffsseett))
This item sets the offset for the duplex function
when operating on the HF bands.
Default is 0.100 MHz.
16 DUP 50M
((dduupplleexx ooffffsseett))
This item sets the offset for the duplex function
when operating on the 50 MHz band.
Default is 0.500 MHz.
17 DUP 144M
((dduupplleexx ooffffsseett))
This item sets the offset for the duplex function
when operating on the 144 MHz band.
Default is 0.600 MHz.
18 DUP 430M
((dduupplleexx ooffffsseett))
This item sets the offset for the duplex function
when operating on the 430 MHz band.
Default is 5.000 MHz.
19 1TOUCH RPTR
((oonnee ttoouucchh rreeppeeaatteerr))
This item sets the offset direction when using the
one-touch repeater function. +duplex or –duplex
can be selected.
Duplex direction is set
to –duplex.
Duplex direction is set to
+duplex.
DUP DUP
14 SPL OFFSET
((sspplliitt ooffffsseett))
This item sets the offset (difference between transmit
and receive frequencies) for the quick split function.
Note that this setting is not valid in FM/WFM modes.
Default is 0.100 MHz.
13 SPLIT LOCK
((sspplliitt lloocckk))
When this item is ON the main dial can be used to
adjust the transmit frequency (XFC) even while the
lock function is activated.
Split lock function OFF
(default)
Split lock function ON
12 QUICK SPLIT
((qquuiicckk sspplliitt ffuunnccttiioonn))
When this item is set to ON, pushing [SPL] for 2 sec.
sets the undisplayed VFO frequency to the dis-
played VFO frequency plus the split offset or duplex
offset, and activates split operation.
Quick split function ON
(default).
Quick split function OFF.
7
SET MODE
IC-706MKIIG.qxd 02.3.27 13:53 Page 52