What to do if programmed scan does not start on Icom Transceiver?
If the programmed scan on your Icom Transceiver doesn't start, program different frequencies in scan edge memory channels P1 and P2.
General| Modes | SSB, CW, RTTY, AM, FM |
|---|---|
| Voltage | 13.8 V DC ±15% |
| Output Power | 200 W (SSB/CW/RTTY/FM) |
| Receiver Type | Superheterodyne |
| Display | 7-inch color TFT LCD |
| Antenna Tuner | Automatic |
| Image Rejection Ratio | More than 70 dB |
| IF Frequencies | 1st: 64.455 MHz, 2nd: 455 kHz |
| Selectivity | 2.4 kHz (SSB), 500 Hz (CW) |
| Current Drain | 2.5 A (receive) |
To Next Page
