6
EXTRA FEATURES
35
D Channel programming
The programmed frequencies, both transmit and re-
ceive, in operating channel can be re-programmed
from the VFO mode.
• Simplex channel programming
q Push [FC] for 1 sec. to enter VFO mode.
w
Push [√ DN]/[UP ∫] to select the desired channel.
• Any channels, even blank channels, can be selected.
• If you want to select the desired channel with keypad,
select the channel before entering VFO mode.
e Tune to the desired receive frequency with the
channel selector, or keypad. (p. 34)
• Selects operating mode and other settings, such as fil-
ter selection, RF attenuator, etc., if necessary.
r Push [ENT] for 1 sec. (3 beeps are emitted), to store
the frequency into the selected channel.
•
Reprogram the channel comment, if necessary. (p. 27)
• Split (duplex) channel programming
q Store receive frequency as instructed above.
w Push [TXF] to indicate the transmit frequency.
• The “TX” indicator blinks.
e Tune to the desired transmit frequency with the
channel selector, or keypad. (p. 34)
r Push [ENT] for 1 sec. (3 beeps are emitted), to store
the transmit frequency into the selected channel.
• The “ ” indicator appears.
D Call channel programming
The programmed frequencies, both transmit and re-
ceive, in call channel can also be re-programmed
from the VFO mode.
➥ Select channel 0 (call channel) with the keypad
in the channel mode or [√ DN]/[UP ∫] in the VFO
mode.
• The channel 0 cannot be selected with the channel se-
lector
• When the channel 0 is selected with [CALL], the stored
frequencies cannot be re-programmed.
• Pushing [FC] for 1 sec. to enter into VFO mode when
channel 0 is selected in channel mode.
➥ Set receive or both receive and transmit frequen-
cies, operating mode and other settings as above,
then push [ENT] for 1 sec. to store into call chan-
nel.
To Next Page
Loading...
