Icom IC-9100 - Page 38

ADJUSTMENT ITEM
TRANSCEIVER'S
CONDITION
OPERATION
MEASURE
POINT
ADJUST
POINT
VALUE
ID ADJUSTMENT
(HF band)
6 • Display: "ID SET HF"
• Transmitting
1) Connect a 50
Ω
dummy load to
[ANT1].
2) Connect an ammeter to the
power supply line.
Power
supply line
– Push [F-5].
(Meaure the
current and
note it as the
reference.)
7 • Display: "HFID1V"
• Transmitting
[MAIN DIAL] 1.0 A more than
the reference.
Push [F-5].
8 • Display: "HFID2V"
• Transmitting
– Push [F-5].
(A beep sounds,
and then
another beeps
sound 3 sec.
later)
9 • Display: "HDID1V"
• Transmitting
[MAIN DIAL] 1.0 A more than
"Step3."
Push [F-5].
10 • Display: "HDID2V"
• Transmitting
– Push [F-5].
(A beep sounds,
and then
another beeps
sound 3 sec.
later)
11 • Display: "HPID1V"
• Transmitting
ID ADJUSTMENT
(VHF/UHF band)
12 • Display: "ID SET VHF"
• Transmitting
• Connect a 50
Ω
dummy loads
to [ANT1], [144MHz ANT] and
[430MHz ANT].
– – Push [F-5].
13 • Display: "VID1V"
• Transmitting
Push [F-5].
(A beep sounds,
and then
another beeps
sound 3 sec.
later)
14 • Display: "VID2V"
• Transmitting
15 • Display: "ID SET UHF"
• Transmitting
Push [F-5].
16 • Display: "UID1V"
• Transmitting
Push [F-5].
(A beep sounds,
and then
another beeps
sound 3 sec.
later)
17 • Display: "UID2V"
• Transmitting
18 • Display: "VUID1V"
• Transmitting
19 • Display: "VUPD1V"
• Transmitting
Automatically returns to the main adjustment menu.
¤
ID ADJUSTMENTS (continued)
4 - 12