31
6
REPEATER AND DUPLEX OPERATIONS
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
■ Duplex operation
Although [DIAL] and [ ](5) are used for description in this
section, [
](2)/[ ](8) and [ ](6) are available instead of
[DIAL] and [
](5).
D Setting offset frequency
q
Enter “OFFSET FREQ” in DUP/TONE… set mode. (p. 110)
w Rotate [DIAL]
†
to set offset frequency.
• 1 MHz and 10 MHz tuning steps are available by pushing and
holding [MHz](VFO) for 1 sec.: push [MHz](VFO) to cancel it.
e Push [ ](5) (or [ ](4)) to return to DUP/TONE… set
mode, and push [MENU/
] to return to frequency indi-
cation.
D Setting duplex direction
➥ Push and hold [DUP](4) for 1 sec. to select “–DUP” (neg-
ative offset) or “+DUP” (positive offset).
• “–DUP” or “+DUP” indicates the transmit frequency for minus
shift or plus shift, respectively.
• When offset frequency is 0.6 MHz.
U.S.A. version:
Auto repeater function has priority over the manual duplex
setting. If the transmit frequency changes after setting, the
auto repeater function may have changed the duplex setting.
†
[DIAL] ↔ [ ](2)/[ ](8)
‡
[ ](5) ↔ [ ](6)
5.0 MHz offset
No offset frequency
5.000.00
To Next Page
Loading...
