Icom IC-9700 - Page 88

4-6
4-3 TRANSMIT ADJUSTMENTS (CONTINUED)
ADJUSTMENT
ADJUSTMENT ITEM
DISPL AY
SETTING CONDITION OPER ATION
VHF Id APC
-Adjustment-
1 ID-APC • Receiving Touch [SET].
2 • Automatically transmitted. Touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
VHF SWR METER
-Preparation-

1 – 
to [144MHz ANT] connector.
–
2 SWR2 (VHF) • Automatically transmitted. Touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
UHF TX OUTPUT
POWER
-Preparation-
1 – • Connect the RF power meter to
the [430MHz ANT] connector.
• Connect the audio generator to
[MIC] connector, and set it to:
Frequency: 1.5 kHz
Waveform: Sine wave
Level: 30 mV rms
Touch [UHF] to enter to the UHF
output power adjustment mode.
-Adjustment- 2 TX POWER UHF SET • Receiving Touch [SET].
3 TX Total UHF Gain • Automatically transmitted. Set to 37.5 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
4 POWER UHF2 MIN Set to 0.5 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
5 POWER UHF2 1% Set to 0.75 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
6 POWER UHF2 10% Set to 7.5 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
7 POWER UHF2 50% Set to 37.5 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
8 POWER UHF2 100% Set to 75 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
UHF TX BALANCE
-Adjustment-
1 POWER UHF Balance SET • Receiving Touch [SET].
2 POWER UHF1 100% • Automatically transmitted. Set to 75 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of each item is completed.)
3 POWER UHF3 100%
4 POWER UHF4 100%
UHF AM CARRIER
POWER RATE
-Adjustment-
1 POWER AM Ratio UHF • Receiving Touch [SET].
2 • Automatically transmitted. Set to 18.75 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
UHF ALC
-Adjustment-
1 ALC UHF • Automatically transmitted. Touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
UHF DRIVE GAIN
-Adjustment-
1 DRIVE UHF • Automatically transmitted. Touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
UHF SWR METER
-Preparation-

1 – 
to [430MHz ANT] connector.
–
2 SWR2 (UHF) • Automatically transmitted. Touch [SET].
(Two beeps sound after adjustment
of the item is completed.)