Icom IC-9700 - Page 89

4-7
4-3 TRANSMIT ADJUSTMENTS (CONTINUED)
ADJUSTMENT
ADJUSTMENT ITEM
DISPL AY
SETTING CONDITION OPER ATION
1.2GHz TX
OUTPUT POWER
-Preparation-
1 – • Connect the RF power meter to
the [1200MHz ANT] connector.
• Connect the audio generator to
[MIC] connector, and set it to:
Frequency: 1.5 kHz
Waveform: Sine wave
Level: 30 mV rms
Touch [1.2G] to enter to the 1.2GHz
output power adjustment mode.
-Adjustment- 2 TX POWER 1.2G SET • Receiving Touch [SET].
3 TX Total 1.2G Gain • Automatically transmitted. Set to 5 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
4 POWER 1.2G3 MIN Set to 0.1 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of each item is completed.)
5 POWER 1.2G3 1%
6 POWER 1.2G3 10% Set to 1 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
7 POWER 1.2G3 50% Set to 5 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
8 POWER 1.2G3 100% Set to 10 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
1.2GHz TX
BALANCE
-Adjustment-
1 POWER 1.2G Balance SET • Receiving Touch [SET].
2 POWER 1.2G2 100% • Automatically transmitted. Set to 10 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of each item is completed.)
3 POWER 1.2G4 100%
4 POWER 1.2G1 100%
1.2GHz AM
CARRIER POWER
RATE
-Adjustment-
1 POWER AM Ratio 1.2G • Receiving Touch [SET].
2 • Automatically transmitted. Set to 2.5 W by [MAIN DIAL], then
touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
1.2GHz ALC
-Adjustment-
1 ALC 1.2G • Automatically transmitted. Touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
1.2GHz DRIVE
GAIN
-Adjustment-
1 DRIVE 1.2G • Automatically transmitted. Touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
1.2GHz SWR
METER
-Preparation-

1 – 
to [1200MHz ANT] connector.
–
2 SWR2 (1.2G) • Automatically transmitted. Touch [SET].
(Two beeps sound after adjustment
of the item is completed.)
• After the adjustment, the transceiver shows the TX/ID adjustment menu.
• Push [EXIT] to return to the main adjustment menu screen.