Icom IC-9700 - D-STAR Network Usage; Talking on the Repeater

• Repeater tone/tone squelch frequency settings
Command: 1B 00, 1B 01
100Hz digit: 0 ~ 2
10 Hz digit: 0
~ 9
1 Hz digit: 0
~ 9
0.1 Hz digit: 0
~ 9
Fixed digit: 0* Fixed digit: 0*
q*
00 X X X
w e
X
*Not necessary when setting a frequency.
D Command formats (Continued)
• DTCS code and polarity setting
Command: 1B 02
0 (fixed) First digit: 0 ~ 7 Second digit: 0 ~ 7 Third digit: 0 ~ 7
Receive polarity: 0=Normal
1=Reverse
Transmit polarity: 0=Normal
1=Reverse
q
XX 0 X X
w e
X
• DV Digital code squelch setting
Command: 1B 07
First digit: 0
~ 9
Second digit: 0
~ 9
q
XX
• DV MY call sign setting
Command: 1F 00
Set your own call sign and note of up to 12 characters.
See “Character’s code of the call sign.”
X X X X X X X X X X X X
o ~ !2q ~ i
∙∙∙∙∙∙∙∙
q ~ i: Your own call sign setting (8 characters)
o ~ !2: Note setting (4 characters)
• DV TX call signs setting (24 characters)
Command: 1F 01
Set “UR,” “R1” and “R2” call signs of 8 characters
(xed).
See “Character’s code of the call sign.”
X X
∙∙∙∙∙∙∙∙
X X X X X X X X X X
∙∙∙∙∙∙∙∙
!7
~
@4o
~
!6q
~
i
∙∙∙∙∙∙∙∙
q ~ i: UR (Destination) call sign setting
(8 characters)
o ~ !6: R1 (Access/Area repeater) call sign setting
(8 characters)
!7 ~ @4: R2 (Link/Gateway repeater) call sign setting
(8 characters)
Character’s code of the call sign
Character ASCII code
0 ~ 9 30 ~ 39
A ~ Z 41 ~ 5A
(Space) 20
/ 2F
• DV TX message setting
Command: 1F 02
Set the transmit message of up to 20 characters.
“FF” stops sending or reading messages.
Character ASCII code Character ASCII code
A ~ Z 41 ~ 5A a ~ z 61 ~ 7A
0 ~ 9 30 ~ 39 Space 20
! 21 # 23
$ 24 % 25
& 26 \ 5C
? 3F " 22
’ 27 ` 60
^ 5E + 2B
– 2D * 2A
/ 2F . 2E
, 2C : 3A
; 3B = 3D
< 3C > 3E
( 28 ) 29
[ 5B ] 5D
{ 7B } 7D
¦ 7C _ 5F
¯ 7E @ 40
Remote control
19