Icom IC-9700 - Page 19

D Command formats (Continued)
• Satellite memory content setting
Command: 1A 07
1, 2 8, 93 ~ 7
3 ~ 
 ~ 
 ~   ~  ~ 
 ~   ~   ~ 
X
  
X ∙∙∙∙∙∙ X X X X X X X X 0 X X 0 X X X X X XX XX X X XX X X XX XX X X XX X
X X ∙∙∙∙∙∙ X X ∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙ ∙∙∙∙∙∙X X X XX X ∙∙∙∙∙∙ X X
X X ∙∙∙∙∙∙ X X
∙∙∙∙∙∙∙∙∙∙∙∙
q, w Satellite memory channel number
0001 ~ 0099: Satellite memory channel 1 to 99
e ~ u Operating frequency setting
See “Operating frequency.” (p. 13)
i, o Operating mode setting
See “Operating mode.” (p. 13)
!0 Data mode setting
1 byte data (XX)
00: Data mode OFF
01: Data mode ON
!1 Tone settings
0 X

0=OFF
1=TONE
2=TSQL
3=DTCS
Fixed
!2 Digital squelch setting
X 0
!2
0=Digital squelch function OFF
1=Digital call sign squelch function ON (DSQL)
2=Digital code squelch function ON (CSQL)
Fixed
!3 ~ !5 Repeater tone frequency setting
!6 ~ !8 Tone squelch frequency setting
See “ Repeater tone/tone squelch frequency
setting.” (p. 19)
!9 ~ @1 DTCS code setting
See “ DTCS code and polarity setting.” (p. 19)
@2 DV Digital code squelch setting
See “DV Digital code squelch setting.” (p. 19)
@3 ~ #0 UR (Destination) call sign setting
(8 characters; xed)
#1 ~ #8 R1 (Access repeater) call sign setting
(8 characters; xed)
#9 ~ $6 R2 (Gateway/Link repeater) call sign setting
(8 characters; xed)
See “DV TX call signs setting.” (p. 19)
$7 ~ ^7 Memory name setting
(16 characters; xed)
See “Codes for character entries.” (p. 15)
NOTE:
• The same data as e ~ $6 are stored in e ~ $6.
• e
~ $6 is used for the uplink frequency (transmit).
• e
~ $6 is used for the downlink frequency (receive).
Remote control
18