Icom IC-E92D Service Manual

5 - 13
5-4 DEVIATION ADJUSTMENTS (continued)
Select an adjustment item using [2] / [8] keys, then set the adjustment value as specifi ed using [DIAL].
ADJUSTMENT ADJUSTMENT CONDITION OPERATION
ADJUSTMENT
ITEM
VALUE
DTMF, European
tone, CTCSS, DTCS
DEVIATION
[PREPARATION]
0 • Supply voltage : 7.4 V • Connect a Modulation
Analyzer to the antenna
through an Attenuator.
• No audio signals are applied.
––
[DTMF]
(VHF)
1 • Displayed freq. : "

"
• Transmitting
• Adjust the deviation using
[DIAL], then release the PTT
and push [BAND] to store the
adjustment value.
[
&6/(
]
3.4–3.6 kHz
(UHF) • Displayed freq. : "

"
• Transmitting
[European tone]
(VHF)
2 • Displayed freq. : "

"
• Transmitting
[
'74
]
(UHF) • Displayed freq. : "

"
• Transmitting
[CTCSS]
(VHF)
3 • Displayed freq. : "

"
• Transmitting
[
%6
]
0.74–0.76
kHz
(UHF) • Displayed freq. : "

"
• Transmitting
[DTCS]
(VHF)
4 • Displayed freq. : "

"
• Transmitting
[
&6%5
]
(UHF) • Displayed freq. : "

"
• Transmitting
MODULATION ANALYZER
(0.1–500 MHz)
SETTING
HPF : OFF
LPF : 20 kHz
De-emphasis : OFF
Detector : (P-P)/2
ATTENUATOR
(30 dB/10 W)
JIG cable
(See the page 5-1)
(4

#(/

5.1

7.4 V
Fusese
(3A)
DC power supply
⊕
−
–
+
Be sure the polarity.
To the battery contact pins

Icom IC-E92D Specifications

General

Brand	Icom
Model	IC-E92D
Category	Transceiver
Language	English