Icom IC-F6013H - Emergency Transmission

12
2
BASIC OPERATION
■ Emergency transmission
When [Emergency] is held down for the specified time pe-
riod*, the emergency signal is transmitted on the specified
emergency channel once, or repeatedly.
When no emergency channel is specified, the call is transmit-
ted on the operating channel.
The repeat emergency signal is automatically transmitted
until you turn OFF the power.
Depending on the preprogramming, receiving a matching
5-tone code cancels the transmission.
If you want to cancel the Emergency function, hold down
[Emergency] for the pre-programmed time period again be-
fore transmitting the call.
If your transceiver is programmed for Silent operation, you
can transmit emergency calls without the beep sounding and
the LEDs lighting.
IMPORTANT:฀It is recommended to set an emergency
channel individually to provide the certain emergency call
operation
.
D NOTES
Depending on the preprogramming, the following functions
are automatically activated. Ask your dealer for details.
•฀Auto฀TX฀function
After the emergency call transmission, audio from the micro-
phone is automatically transmitted for a specified time pe-
riod.*
•฀The฀HM-148G฀or฀HM-152฀hand฀microphone฀is฀required.
•฀Auto฀RX฀function
After the emergency call transmission, the transceiver stands
by in the audible mode for the specified time period.*
* Depending on the preprogramming. Ask your dealer for de-
tails.