SET MODE
5
13
■ SET mode items
D Beep tone “bP”
You can select silent operation by turning beep tones OFF or
you can have confirmation beeps sound at the push of a
switch by turning beep tones ON. The beep tone volume is
linked with [OFF/VOL].
D Automatic backlighting “bL”
This function is convenient for nighttime operation. The auto-
matic backlighting turns the backlighting ON when pushing
any key except for [PTT].
•
The backlighting is automatically turned OFF 5 sec. after operation.
•Push [SQL] to turn the backlighting ON without changing the oper-
ating condition.
■ SET mode programming
SET mode is used to change the conditions of 6 transceiver
functions: the beep tone function, the automatic backlighting,
weather alert function, normal/priority scan, scan resume
timer and auto scan function.
1 Turn power OFF.
2 While pushing [SQL], turn power ON and continue push-
ing [SQL] until “bP” appears.
3 After the display appears, release [SQL].
4 Push [SQL] to select the desired item, if necessary.
5 Rotate the channel selector to select the desired condition
of the item.
6 To exit SET mode, push [16].
- Turning power OFF, then ON again also exits SET mode.
To Next Page
Loading...
Need help?
General
