■ Setting tag channels
For more efficient scanning, add desired channels as tag
channels or clear tag channels for unwanted channels.
Channels, set as non-tag channels will be skipped during
scanning. Tag channels can be assigned to each channel
group
(USA, INT, CAN) independently.
q Select the desired channel group
(USA, INT, CAN) by push-
ing [CH/WX•U/I/C] for 2 sec., if desired.
w Select the desired channel to set as a tag channel.
e Push [SCN•TAG] for 2 sec., to set the displayed channel
as a tag channel.
•“TAG” appears in the function display.
r To cancel the tag channel setting, push [SCN•TAG] for 2
sec.
•“TAG” disappears.
•Clearing all tag channels in the selected channel group
➥Turn power ON while pushing and holding [SCN•TAG] to
clear all tag channels in the channel group.
■ Starting a scan
Set scan type, weather alert function, scan resume timer and
auto scan function in advance, using SET mode. (pgs. 17, 18)
q Select the desired channel group (USA, CAN, INT) by
pushing [CH/WX•U/I/C] for 2 sec., if desired.
•When the weather alert function is in use, select the desired
weather channel with [CH/WX] and the channel selector.
w Push [SCN] to start priority or normal scan.
•The comment indicator flashes “SCAN”.
•The sub channel readout indicates “16” during priority scan.
•When a signal is received, scan pauses until the signal disap-
pears or resumes after pausing 5 sec. according to SET mode
setting. (Channel 16 is still monitored during priority scan.)
•Push [Y]/[Z] to check the scanning tag channels, to change
the scanning direction or resume the scan manually.
e To stop the scan, push [SCN].
•“SCAN” disappears.
•Pushing [PTT], [16•9], [CH/WX] or [DW•TRI] also stops the scan.
5
SCAN OPERATION
13
To Next Page
Loading...
