Icom IC-M1V

11
TROUBLESHOOTING
23
POSSIBLE CAUSE
•The battery is exhausted.
•Bad connection of the battery pack.
•Squelch level is too deep.
•[VOL] level is too low.
•Some channels are for low power or
receive only.
•The battery is exhausted.
•The output power is set to low or extra
low.
•Lock function is activated.
•“TAG” channel is not programmed.
•Auto scan function is activated.
•Beep tone is turned OFF.
•Optional voice scrambler is turned OFF.
•Scramble code is not set correctly.
PROBLEM
No power comes ON.
No sound comes from
the speaker
Transmitting is impossi-
ble, or high power can-
not be selected.
The displayed channel
cannot be changed.
Scan does not start.
Scan starts automati-
cally.
No beep sounds.
Receive signal cannot
be understood.
SOLUTION
•Recharge the battery pack.
•Check the connection to the transceiver.
•Set squelch to the threshold point.
•Set [VOL] to a suitable level.
•Change channels.
•Recharge the battery pack.
•Push [H/L] to select high power.
•Push [H/L•LOCK] for 2 sec. to cancel the
lock function.
•Set the desired channels as “TAG” chan-
nels.
•Cancel the auto scan function in SET
mode.
•Turn the beep tone ON in SET mode.
•Turn the optional voice scrambler ON.
•Reset the scramble code.
REF.
p. 21
p. 2
p. 9
p. 9
p. 7
p. 21
p. 9
p. 10
p. 13
p. 18
p. 16
p. 10
p. 19