How to unlock channels on Icom IC-M24?
If the displayed channel on your Icom Transceiver cannot be changed, the Lock function may be activated. To turn it OFF, hold down [ ] (Hi/Lo) for 1 second.
Why is there no sound from my Icom IC-M24 speaker?
If there's no sound coming from the speaker of your Icom Transceiver, the squelch level might be set too high; try adjusting it to the threshold level. Alternatively, the volume level could be too low, so increase it to a suitable level. Finally, if the speaker has been exposed to water, remove the water from the speaker grill.
How to fix Icom IC-M24 that does not turn ON?
If your Icom Transceiver won't turn on, the battery may be exhausted; try recharging it. Also, ensure the battery pack is correctly inserted into the transceiver.
What to do if transmitting is impossible or high power can not be selected on Icom IC-M24 Transceiver?
If you can't transmit or select high power on your Icom Transceiver, some channels may be limited to low power or receive-only; try changing the channel. Also, check if the output power is set to low; push [Hi/Lo] to select high power. Finally, the battery may be exhausted; recharge it.
How to turn on beep sounds on Icom IC-M24?
If there are no beep sounds on your Icom Transceiver, the Beep Tone function may be turned OFF. Turn ON the Beep Tone in the set mode.
Why scan does not start on Icom IC-M24?
If the scan does not start on your Icom Transceiver, desired channels may not be programmed as “TAG” channels. Set desired channels as “TAG” channels.
General| Type | Handheld VHF Marine Transceiver |
|---|---|
| Frequency Range | 156.000 - 163.425 MHz |
| Output Power | 5W / 1W |
| Waterproof Rating | IPX7 |
| Type of Emission | 16K0G3E |
| Battery Life | Approx. 10 hours (with BP-288) |
To Next Page
