Icom IC-M32

7 - 2
A
B
MP1 (C)
SP1 (C)
NOTE2
NOTE1
NOTE1
MP4 (C)
MP46 (C)
MP6 (C)
NOTE3
MP7 (C)
NOTE3
W1 (C)
MP8 (C)
MP9 (C)
MP5 (C)
NOTE2
MP361 (M)
DS246 (M)
MP360 (M)
EP360 (M)
J31 (C)
NOTE1
MP31 (C)
MP42 (C)
MP42 (C)
NOTE4
MP21 (M)
MP43 (C)
MP40 (C)
MP36 (C)
MP35 (C)
MP33 (C)
MP37 (C)
MP44 (C)
MP362 (M)
MP39 (C)
MP39 (C)
MP39 (C)
MP39 (C)
MC250 (M)
MP39 (C)
MP38 (C)
MP34 (C) MP44 (C)
MP14 (C)
NOTE1
MP32 (C)
MP21 (C)
MP22 (C)
MP23 (C)
MP24 (C)MP25 (C)
NOTE1
MP23 (C)
MP23 (C)
MP7 (C)
MP6 (C)
Front side Rear side
MP2 (C)
NOTE2
MAIN unit
Speaker
Window
Plate
9-key
<Rear view of the front panel>
MP15 (C)
MP16 (C)
MP17 (C)
MP47 (C)
2.8 (1/8)
2.3 (3/32)
56.2 (2 7/32)
58.4 (2 5/16)
8.5 (11/32)
41 (1 5/8)
4.7 (3/16)
36.1 (1 3/32)
136.1 (5 11/32)
165 (6 1/2)
135 (5 5/16)
0.3 (1/32) 0.3 (1/32)
136 (5 11/32)
UNIT abbreviations (C): CHASSIS PARTS, (M): MAIN UNIT
NOTE1
Once the following parts are removed, a O ring or sealing must be replaced
with new one before reattachement.
Mother part . . . . . . . . . . . . . . . . . . Daughter part for relayted replacement
J31 (C) Antenna connector . . . . . . MP14 (C) Sealing washer
MP24 (C) Screw . . . . . . . . . . . . . . MP25 (C) Sealing washer
NOTE2
The glue must be applied to the
areas when the front panel is
replaced with new one, to ensure
water tightness.
Manufacture : Semedain Co.
Type : Super-X
NOTE3
Once the 2497 PTT button (MP6 (C)) or
the 2497 PTT holder (MP7 (C)) is
removed, the glue must be applied
between the 2497 PTT button or the
2497 PTT holder and 2691 front panel.
NOTE4
MP42 (C)
A : For IC-M2A only
B : For IC-M32 only
<A figure of measurement>
UNIT : mm (inch)
NOTE: The MP31 (C) is a common
parts for IC-M2A and IC-M32. Need to
screw the MP42 (C) to the B location
for IC-M32.