Icom IC-M324 - NMEA Output and Remote ID

64
7
DSC OPERATION
■ Receiving DSC calls (Continued)
DAlarm
Set the Alarm function ON or OFF, depending on the Cat-
egory or Status.
Enter “ALARM” in the DSC Settings menu. q
MENU ➪ DSC Settings ➪ Alarm
(Push [MENU].) (Rotate Dial, then push [ENT].)
Rotate Dial or push [ w Y]/[Z] to select the status, then push
[ENT].
 •Push[BACK]toreturntothepreviousscreen.
 •“Safety,”“Routine,”“Warning,”“Self-Terminate,”and“Discrete”are
selectable. (default: ON )
Rotate Dial or push [ e Y]/[Z] to set the Alarm setting to “ON”
or “OFF.”
Push [EXIT] to return to the normal operating mode. r
D Channel 70 Squelch level
Set the squelch level on Channel 70.
The transceiver has 11 squelch levels between 1 (loose
squelch) and 10 (tight squelch) and OPEN.
OPEN is completely open.
Enter “CH 70 SQL LEVEL” in the DSC Settings menu. q
MENU ➪ DSC Settings ➪ CH 70 SQL Level
(Push [MENU].) (Rotate Dial, then push [ENT].)
Rotate Dial or push [ w Y]/[Z] to adjust the squelch level until
the noise just disappears, then push [ENT].
 •Push[BACK]tocancelandreturntotheDSCSettingsmenu.
(default)
Push [EXIT] to return to the normal operating mode. e