Icom IC-M324 - Maintenance Procedures

67
7
DSC OPERATION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
After making the individual DSC call, the transponder will r
display “DSC Transmission COMPLETED.”
 •Push[CLEAR]toreturntothescreendisplayedbeforeyouen-
tered the voice channel selection screen in step w.
 •ThetransceiverstandsbyonChannel70untilanacknowledge-
ment is received.
Step 2: Transceiver’s operation
When the acknowledgement is received, alarm sounds. t
If the acknowledgement ‘Able to comply’ is received, ➥
push [ALARM OFF] to stop the alarm, and then select
the intership channel specified in step w.
  •Adifferentintershipchannelwillbeselectedifthestationyou
called cannot use the channel.
  •Toreply,push[PTT]andspeakatyournormalvoicelevel.
  •YoucanchecktheMMSIcodeorthename,ifentered,ofthe
AIS target on the display.
If the acknowledgement ‘Unable to comply’ is received, ➥
push [ALARM OFF] to stop the alarm, and then “INDI-
VIDUAL CALL FAILED” is displayed.
After your communication is finished, push [EXIT] to return y
to the normal operating mode.
Transponder’s display Transceiver’s display
[DSC]
[CLEAR]
[Z]
[Y]
TRANSPONDER
‘Able to comply’ is received
‘Unable to comply’ is received