Icom IC-M421

14
DSC OPERATION
New2001
6
■ MMSI code programming
The 9-digit MMSI (Maritime Mobile Service Identity: DSC self
ID) code can be programmed at power ON.
This code programming can be performed only once.
q Turn power OFF.
w While pushing [MENU], turn power ON to enter MMSI
code programming condition.
e After the display appears, release [MENU].
r Push [MENU] again to enter the DSC menu.
t Push [▲] or [▼] to select “Set up,” push [ENT].
y Push [▲] or [▼]
to select “MMSI Check,” push [ENT] .
u Push [▲] or [▼] to set the specific 9-digit MMSI code.
•
Push [CH•DUAL] or [16•C] to move the cursor forward or back-
ward, respectively.
• Push [SCAN•TAG] to clear the MMSI code.
• Push [CLR] to cancel and exit the condition to the set up menu.
i After input the 9-digit code, push [ENT] to set the code.
• Returns to the set up menu.
o Push [CLR] or [▼] to select “Exit,” push [ENT].
• Returns to the DSC menu.
• Repeat again to return to the normal operation condition.
--DSC Menu--
MMSI Check
Input 9 digits
_________
<CLR˘Exit / ENT˘OK>
--DSC Menu--
Set up
DEL:INDV ID ≤
DEL:Group ID
Offset Time
˘MMSI Check ≥
--DSC Menu--
Select Item
Position Input
Received Calls
˘Set up
Exit
!IC-M421-3.qxd 06.5.26 1:43 PM Page 14 (1,1)