34
6 DSC OPERATION
New2001
DD
Transmitting a position reply call
Transmit a position reply call when a position request call is
received.
q Push [MENU] to enter the DSC menu.
w Push [▲] or [▼] to select “Position Reply,” and
push [ENT].
•“Position Reply” item appears after a position request
call is received.
e Push [▲] or [▼] to select the desired individual address or
ID code, push [ENT].
When a GPS receiver (NMEA0183 ver. 2.0 or 3.01) is con-
nected,
next steps r, t (
Current position/time program-
ming) do not appear. Go to step y.
r The position information appears. Set your latitude data
using [▲] or [▼]. After setting the latitude data, push [ENT]
to set your
longitude data
.
• Push [CH•DUAL] or [16•C] to move the cursor forward or back-
ward, respectively.
• Push [▲] or [▼] to edit N; North latitude or S; South latitude
when the cursor is on the ‘N’ or ‘S’ position, and W; West longi-
tude or E; East longitude when the cursor is on the ‘W’ or ‘E’ po-
sition.
• Push [SCAN•TAG] to clear the latitude/
longitude
data.
• Push [CLR] to cancel and exit the condition to the DSC menu.
Set the latitude data
Set the longitude data
To Next Page
Loading...
