Icom IC-M422 - 8 Set Mode; I Set Mode Programming; I Set Mode Items

32
SET MODE
New2001
8
■ Set mode programming
Set mode is used to change the conditions of the trans-
ceiver’s functions: Scan type, Scan resume timer, Weather
alert, Dual/Tri-watch, DSC watch, Beep tone, LCD backlight,
LCD contrast, Auto acknowledgement and Radio power.*
Available functions may differ depending on dealer setting.
q Turn power OFF.
w While pushing [16•
9], turn power ON to enter Set mode.
• “” appears at the channel comment indicator.
e After the display appears, release [16•9].
r Push [16•
9
] to select the desired item, if necessary.
t Push [Y] or [Z] to select the desired condition of the item.
y Turn power OFF, then ON again to exit Set mode.
*Available only when optional HM-157 is connected.
■ Set mode items
D Scan type
The transceiver has 2 scan types: Normal scan and Priority
scan. Normal scan searches all TAG channels in the selected
channel group. Priority scan searches all TAG channels in se-
quence while monitoring Channel 16.
DD
Scan resume timer
The scan resume timer can be selected as a pause (OFF) or
timer scan (ON). When OFF is selected, the scan pauses
until the signal disappears. When ON is selected, the scan
pauses 5 sec. and resumes even if a signal has been re-
ceived on any other channel than Channel 16.
Scan timer OFF (default) Scan timer ON
Normal scan (default) Priority scan
D SET MODE CONSTRUCTION
: Push
• Scan type
“ ”
• DSC watch
“ ”
• Dual/Tri-watch
“ ”
• Weather alert
“ ”
• Scan resume timer
“ ”
• Beep tone
“ ”
• Radio PWR*
“ ”
• Auto ACK
“ ”
• Contrast
“ ”
• Backlight
“ ”
Starting item
!IC-M422.qxd 05.2.23 2:21 PM Page 32 (1,1)