Icom IC-M423GE - Page 57

47
7
DSC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
D Making a Test Acknowledgement call
When the “TEST ACK” in DSC settings is set to ‘Auto TX’
(p. 65), the transceiver automatically transmits a reply call
when a Test call is received.
Quick ACK:
q When a Test call is received, alarm sounds and the screen
shown below is displayed.
Push [ALARM OFF] to stop the alarm.
w Push [ACK].
• Push [EXIT] to return to the normal operating mode.
• Push [INFO] to display the Test call information.
About Received call information:
• Push [EXIT] to return to the normal operating mode.
• Push [BACK] to return to the previous screen.
• Push [ACK] to go to the next step.
e The Test ACK confirmation screen is displayed.
Push [CALL] to make an acknowledgement call.
r While transmitting the acknowledgement call, the screen
shown below is displayed, and then returns to the normal
operating mode.