Icom IC-M423GE - Making DSC Calls

32
7
DSC OPERATION
■ Making DSC calls
To ensure correct operation of the DSC function, make
sure you correctly set the CH70 SQL LEVEL. (p. 67)
D Making an individual call
The Individual call function allows you to make a DSC call to
only a specific station.
q Enter “INDIVIDUAL CALL” in the DSC CALLS menu.
MENU ➪ DSC Calls ➪ Individual Call
(Push [MENU].) (Rotate Dial, then push [ENT].)
w Select a desired preset individual address, or “Manual In-
put,” using Dial or [Y]/[Z], then push Dial or [ENT].
• The ID code for the Individual call can be entered first. (p. 22)
• When “Manual Input” is selected, enter a desired 9 digit MMSI ID
code for the individual you wish to call.
• Push [EXIT] to return to the normal operating mode.
• Push [BACK] to return to the previous screen.
About Manual Entry:
Enter a desired individual ID in the following way:
• Select a desired number using Dial, or [Ω]/[≈].
• Push [ENT] or Dial to set it.
• To move the cursor, select either arrow, “←” or “→,” then push
[ENT] or Dial.
• The first digit is specified as ‘0’ for a Group ID. If a 9 digit Group
ID is entered, an error beep sounds when pushing [ENT] or dial.
• The first two digits are ‘0’ for any coast station ID.
NOTE: When a coast station is selected in step w, the
voice channel is automatically specified by the coast sta-
tion. Therefore, skip step e and go directly to step r.