Icom ic-m424g - DSC Operation: Position Replies; Replying to Position Requests

47
7
DSC OPERATION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Making a D Position Reply call
Make a Position Reply call when a Position Request call is
received.
When the “POSITION ACK” in DSC Settings is set to ‘Auto
TX’ (p. 63), the transceiver automatically transmits a reply call
when a Position Request call is received.
Quick Reply:
When a Position Request call is received, alarm sounds q
and the screen shown below is displayed.
Push [ALARM OFF] to stop the alarm.
Push [ACK]. w
 •Push[EXIT]toreturntothenormaloperatingmode.
 •Push[INFO]todisplaytheTestcallinformation.
About Received call information:
•Push[EXIT]toreturntothenormaloperatingmode.
•Push[BACK]toreturntothepreviousscreen.
•Push[ACK]togotothenextstep.
The Position Reply confirmation screen is displayed. e
Push [CALL] to make a reply call.
While transmitting the reply call, the screen shown below r
is displayed, and then returns to the normal operating
mode.