What to do if transmitting is impossible on Icom IC-M603?
If you're unable to transmit or select high power on your Icom Transceiver, it could be due to a couple of reasons. Some channels might be programmed for low power or receive-only operation due to regulations, so try changing channels. Alternatively, the output power may be set to low; push [H/L] to select high power.
Why distress call cannot be transmitted on Icom IC-M603 Transceiver?
If a distress call cannot be transmitted from your Icom Transceiver, the cause might be that the MMSI (DSC self ID) code is not programmed. Program the MMSI (DSC self ID) code.
Why is there no sound coming from my Icom Transceiver speaker?
If you're not getting any sound from the Icom Transceiver speaker, there might be a few reasons: 1. The squelch level could be set too high. Try adjusting the [SQL] to the threshold point. 2. The volume level might be too low. Increase the volume by adjusting [VOL] to a suitable level. 3. The speaker may have been exposed to water. If so, drain the water from the speaker.
What to do if my Icom Transceiver cannot transmit or use high power?
If you can't transmit or select high power on your Icom Transceiver, it could be due to a couple of reasons: * Some channels might be programmed for low power or receive only, according to regulations. Try changing channels. * The output power might be set to low. Push [H/L] to select high power.
What to do if the distress call cannot be transmitted on Icom IC-M603?
If the distress call cannot be transmitted from your Icom Transceiver, ensure that the MMSI (DSC self ID) code is programmed. Program the MMSI (DSC self ID) code.
Why no sound comes from the Icom Transceiver speaker?
If no sound is coming from the speaker of your Icom Transceiver, there might be a few reasons. First, the squelch level could be set too high; try adjusting the [SQL] to the threshold point. Also, check that the volume isn't too low by adjusting [VOL] to a suitable level. Finally, if the speaker has been exposed to water, drain the water from it.
How to fix Icom IC-M603 that does not turn ON?
If your Icom Transceiver doesn't turn on, the cause might be a bad connection to the power supply. Check the connection to the transceiver.
Why Icom IC-M603 Transceiver has no beeps sound?
If you are not hearing any beeps from your Icom Transceiver, there are a couple of potential causes. First, check if the beep tones are turned OFF in Set mode and turn them ON. Secondly, the squelch might be open; in this case, set [SQL] to the threshold point.
What to do if scan does not start on Icom IC-M603 Transceiver?
If the scan function does not start on your Icom Transceiver, it might be because a TAG channel is not programmed. Set the desired channels as TAG channels.
Why is my Icom Transceiver not making any beeps?
If your Icom Transceiver isn't beeping, it could be because the beep tones are turned OFF. Turn the beep tone ON in Set mode. Alternatively, the squelch might be open. In that case, set [SQL] to the threshold point.
General| Type | Marine VHF Transceiver |
|---|---|
| Waterproof Rating | IPX7 |
| Power Supply | 13.8 V DC |
| GPS | Yes |
| DSC | Yes |
| NMEA connectivity | Yes |
| Output Power | 25W |
| Weight | 1.4 kg |
| Modulation | FM |
| Frequency Range | 156.000 - 163.425 MHz |
To Next Page
