To Next PageTo Next PageHow to fix a program scan that does not operate on my Icom Receiver?
If the program scan does not operate on your Icom Receiver, it could be due to: * The squelch being open. Set the squelch to the threshold point. * The start and end frequencies being the same. Program different start and end frequencies.
What to do if memory scan does not operate on Icom Receiver?
If the memory scan does not operate on your Icom Receiver, it could be due to: * The squelch being open. Set the squelch to the threshold point. * Only 1 memory channel being programmed, or other channels are set as skip channels. Program other memory channels or cancel the memory skip function in the desired channels.
Why is there no sound coming from my Icom Receiver speaker?
If no sound comes from the speaker of your Icom Receiver, there might be several reasons: * The volume level may be too low. Adjust the [VOL] control to a suitable level. * The squelch level may be set too high. Adjust the [SQL] control to properly set the squelch level. * The selected tone or DTCS squelch may not match the received signal. In this case, turn the appropriate function OFF.
What to do if the frequency cannot be changed on my Icom Receiver?
If you cannot change the frequency on your Icom Receiver, the lock function may be activated. To deactivate it, push and hold [PWR• ] for 2 seconds after powering on the device.
Why is the sensitivity low on my Icom Receiver and only strong signals are audible?
If the sensitivity is low on your Icom Receiver, and only strong signals are audible, it could be due to: * A poor contact or short circuit in the antenna feedline or antenna connector. Check the connection, and if necessary, replace the feedline or reattach the antenna connector. * The attenuator function being activated. Push [ATT•PRIO] to turn the Attenuator function OFF.
What to do if my Icom Receiver receive audio is distorted?
If the receive audio on your Icom Receiver is distorted, the operating mode may not be selected correctly. Push and hold [MODE•SCAN] for 1 second, then rotate [DIAL] to select a suitable operating mode.
Why won't my Icom Receiver turn on?
If your Icom Receiver does not turn on, it may be because the AC adapter is not fully seated in the power jack on the rear panel. Check the connection to ensure it is properly connected.
General
