Icom IC-T90 - Page 58

53
7
PRIORITY WATCH
D VFO scan with memory scan watch
While scanning in VFO mode, priority watch checks for sig-
nals in memory channels every 5 sec.
q Select memory mode.
w Push [MODE SCAN] for 1 sec. to start a memory scan.
• Start the memory scan first, otherwise, memory scan watch does
not start.
e Push [8 SET] for 1 sec. to enter set mode.
r Rotate [DIAL] until “PRIO” appears.
t Push [8 SET] to select the priority watch item.
y Rotate [DIAL] to select the priority watch (“ON”) or priority
watch with alert (“BELL”).
u Push [VFO] to exit set mode and start the memory scan
watch.
i Push [MODE SCAN] for 1 sec. to start a VFO scan. (full
scan, band scan or programmed scan)
• VFO scan with memory scan watch is now activated.
• The scan or watch pauses when a signal is received on a VFO
frequency or memory channels select for watch.
o Push [VFO] while the display shows the VFO frequency to
stop the VFO scan and priority watch.
DCall channel watch
While operating on a VFO frequency, priority watch checks
for a signal in the selected call channel every 5 sec.
q Select VFO mode; then, set an operating frequency.
w Push [CALL/TV] to select call channel mode.
e Rotate [DIAL] to select the desired call channel.
r Push [8 SET] for 1 sec. to enter set mode.
t Rotate [DIAL] until “PRIO” appears.
y Push [8 SET] to select the priority watch item.
u Rotate [DIAL] to select the priority watch (“ON”) or priority
watch with alert (“BELL”).
i Push [VFO] to exit set mode and start the priority watch.
o Push [VFO] while the display shows the VFO frequency to
stop the watch.
FM
PRIO
SKIPPFM
PRIO
Checks for a signal in the selected
call channel every 5 sec.
While operating on a VFO
frequency
The watch stops on the selected
channel when a signal is received.
IC-T90A_IM.qxd 02.6.6 08:44 AM Page 56 (1,1)