Icom ID-800H

5 - 4
5-3 SOFTWARE ADJUSTMENT
ADJUSTMENT
ITEM
ADJUSTMENT CONDITION DISPLAY OPERATION
REFERENCE
FREQUENCY
[Fr]
1 • Operating freq. : 435.000 MHz [EXP]
445.000 MHz [USA]
• Connect an RF power meter or dummy
load to the antenna connector.
• Loose couple a frequency counter to the
antenna connector.
• Transmitting
• Rotate [DIAL] to set to the frequency
as below.
• Push [BAND].
VHF TX
OUTPUT
POWER [Po]
(High)
1 • Operating freq. : 145.000 MHz [EXP]
146.000 MHz [USA]
• Connect an RF power meter to the
antenna connector.
• Transmitting
• Rotate [DIAL] to set the VHF high
power to 56 W.
• Push [BAND].
(Middle) 2 • Transmitting • Rotate [DIAL] to set the VHF middle
power to 15 W.
• Push [BAND].
(Low) 3 • Transmitting • Rotate [DIAL] to set the VHF low
power to 5 W.
• Push [BAND].
UHF TX
OUTPUT
POWER [Po]
(High)
1 • Operating freq. : 435.000 MHz [EXP]
445.000 MHz [USA]
• Transmitting
• Rotate [DIAL] to set the UHF high
power to 51 W.
• Push [BAND].
(Middle) 2 • Transmitting • Rotate [DIAL] to set the UHF middle
power to 15 W.
• Push [BAND] key.
(Low) 3 • Transmitting • Rotate [DIAL] to set the UHF low
power to 5 W.
• Push [BAND].
TRANSMIT
MINIMUM
VOLTAGE
[PL]
1 • Operating freq. : 430.000 MHz [EXP]
440.000 MHz [USA]
• Connect an RF power meter to the
antenna connector.
• Transmitting
• Rotate [DIAL] to set to 1 W.
• Push [BAND].
2 • Operating freq. : 435.000 MHz [EXP]
445.000 MHz [USA]
• Transmitting
3 • Operating freq. : 438.000 MHz [EXP]
450.000 MHz [USA]
• Transmitting
PROTECT
VOLTAGE
[PV]
1 • Operating freq. : 145.000 MHz [EXP]
146.000 MHz [USA]
• RF power : High
• Connect an RF power meter to the
antenna connector.
• Transmitting
• Push [BAND].
2 • Operating freq. : 435.000 MHz [EXP]
445.000 MHz [USA]
• Transmitting
Version Adjustment freqency
EXP 435.000 MHz
USA 445.000 MHz