Icom ID-800H

SECTION 3 DISASSEMBLY INSTRUCTIONS
• REMOVING THE MAIN UNIT AND CODEC BOARD
1 Unscrew 4 screws A, and remove the cover.
2
Disconnect the cable B from J505, and remove the speaker.
3 Remove 2 cube shaped rubbers C.
Continue to right above.
3 - 1
4 Disconnect the cable D from J508.
5 Disconnect the cable E from J1.
6 Unscrew 3 screws F, and remove the shield cover G.
7 Remove the CODEC board from J507.
8 Unsolder 3 points H.
J505J505
B
C
A
A
J1
J508
F
G
E
D
VCO
H
CODEC board
J507
9 Unscrew 8 screws I, and remove the MAIN unit.
I
MAIN UNIT