Icom IP501H - Lone Worker Function; Man Down Function

3
ADVANCED OPERATION
3-13
■ Lone Worker function
When the Lone Worker function is activated, the Emergency function (p. 3-12) is automatically turned ON after the IP501H
has been left without any operation for the specied time period.
To reset the timer, operate any key or the volume control within the specied time period.
L This function may be used only when the Lone Worker function is programmed by your dealer.
■ Man Down function
When the Man Down function is activated, the Emergency function (p. 3-12) is automatically turned ON after the set period
of time has passed with the IP501H leaning past the preset angle.
To reset the timer, raise back the transceiver from the preset angle towards the vertical position within this set time period.
L This function may be used only when the Man Down function is programmed by your dealer.
NOTE:
Icom is not responsible for the destruction or damage caused by using the Lone Worker or Man Down function.
These functions may not properly work, depending on the following circumstances or conditions:
• Remaining battery capacity is low.
• Surrounding area or environment.
• The Lone Worker and Man Down function are not designed for secured communications.