Icom IP501H - Pairing IP501 H with BC-218 or VS-3

5
OPTIONAL PRODUCTS
5-12
1. Turning ON the Bluetooth function
1. While holding down [FUNC], turn ON the transceiver power.
• Enters the Set mode.
2. Release [FUNC] when “SET” is displayed.
3. Push [FUNC] several times to select “Bluetooth.”
4. Push [▲]/[▼] to select “Enable.”
5. Push [CLR/LOCK].
• Exits the Set mode.
■ Pairing the IP501H with the BC-218 or VS-3
– – –
LOG
SET
Enable
Bluetooth
SET
[FUNC]キー
[▲]/[▼]キー
[CLR/LOCK]キー
[電源/音量]ツマミ
Pairing is a process to be able to establish a connection between a headset and other Bluetooth devices. Once pairing is
established with the device, there is no need to pair again.
• You may not nd a target Bluetooth device if there are many other Bluetooth
®
devices nearby. In that case, stop using
those devices, or move away from them.
• When the Bluetooth function is turned OFF, the audio is output from the IP501H. Be sure to not set the IP501H's
volume level too high.
LGuaranteed Bluetooth devices are the BC-218 and VS-3. (as of December 2017)
[PWR/VOL]
[FUNC]
[CLR/LOCK]
[▲]/[▼]